Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Fast, Reliable Gate Repair Across Lauderdale-by-the-Sea
Most gate repairs in Lauderdale-by-the-Sea take us between 90 minutes and three hours once we’re on site, and we can typically dispatch to the town within a day of your call. If your gate is binding, sagging, or the operator has stopped answering, call (754) 666-7602 and a live person picks up on our end, no phone tree. We know this town’s gates the way a local mechanic knows beachfront cars: the salt is in everything, and the failures follow a pattern. The difference between a gate that lasts three years here and one that lasts twelve is almost always material selection and how the posts were set in the first place.
Why Vance Gate Repair Boca Raton Is Lauderdale-by-the-Sea’s Preferred Gate Repair Company
Lauderdale-by-the-Sea is a one-square-mile town with a lot of gates per block, from El Mar Drive condos to single-family homes off Commercial Boulevard. We’ve worked on gates within sight of the fishing pier and on the quiet residential streets west of A1A, and the failure modes are consistent: salt-corroded hinges, posts that have heaved in sandy soil, and operators that died because the control board sat in humid, salt-laden air for half a decade. We dispatch crews from our South Florida office, and the technician who shows up has a name you’ll know before arrival, not a mystery van.
Our Gate Repair team leaves every job with a written record: photos of what was found, the part numbers installed, and the exact limit-switch or torque settings dialed in. That record is yours to keep and ours to reference if anything shifts later. Under our Haven Standard, the written price sits in your hand before anyone picks up a tool, and the 365-Day Done Right Promise means that if a repair isn’t right within a full year, we come back and make it right without a new invoice.
Our Gate Repair Services in Lauderdale-by-the-Sea

Electric Gate Repair
When an electric gate won’t open on A1A at 7 a.m. with a car behind it, the problem is usually the control board, the limit switch, or the photo-eye alignment, and sometimes all three. We carry boards and safety edges for LiftMaster, FAAC, BFT, Linear, and DoorKing operators, which covers most of what’s installed in Lauderdale-by-the-Sea’s condominium and driveway gates. A board replacement here often takes under an hour once the panel is open, and the new settings get photographed before the cover goes back on.

Automatic Gate Repair
Automatic gates in Lauderdale-by-the-Sea work harder than almost anywhere else in Broward County. Short-term rental turnover on streets like Bougainvilla Drive and Sea Ranch Drive means gates cycle dozens of times on a single Saturday, and the loop detector and limit switch wear at rates you’d never see at a single-family home in Lighthouse Point. We diagnose the cycle-count failures, replace the worn sensor or switch, and set the operator travel so the gate isn’t slamming against its end stops eighty times a weekend.

Hinge & Post Repair
The hinge post is where most Lauderdale-by-the-Sea gates fail, because the post is the part you can’t see. Original installations from the 1950s and 1960s often used galvanized steel posts set in shallow concrete, and after five or six decades of salt spray and storm surge, the post moves or the hinge welds rot through. We reset posts with deeper concrete footings and rebuild hinges with stainless barrel and leaf assemblies rated for direct oceanfront exposure. If the post is too far gone, we’ll tell you that before we touch it, and show you why with a photo.

Gate Realignment
A swing gate that drags on the paver or a slide gate that binds halfway down its track isn’t a sign that the gate is “old” and should be scrapped. It’s a sign that the post shifted or the rack and pinion is out of plane, and both are fixable. We realign gates throughout Lauderdale-by-the-Sea, from the mid-century homes north of Terra Mar Drive to the condo buildings near El Prado Park, and you’ll get a written record of the alignment measurements before and after.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in Lauderdale-by-the-Sea
We work on nine major gate-automation brands, and for Lauderdale-by-the-Sea specifically we most often see Linear, Viking, Ghost Controls, and DoorKing operators on residential and small-condo gates. That matters because the right repair on a Linear swing-gate arm is different from the right repair on a Ghost Controls board, and we don’t steer you toward replacing a motor we can service. We keep common boards, limit switches, and safety edges in local stock, which shortens the wait when your gate is down on a Friday afternoon.
Common Gate Repair Problems We See in Lauderdale-by-the-Sea Homes

- Rusted-through hinge posts on original 1950s-1970s gates. Wrought iron and galvanized steel lower rails corrode from the inside out after decades of direct ocean wind. We often find the post still standing but the base swelled and split below the concrete line.
- Limit switch and loop detector failures in vacation rental buildings. A gate that cycles hundreds of times during a holiday turnover weekend wears out travel sensors years ahead of schedule. The symptom is a gate that stops mid-travel or refuses to close after an entry.
- Heaved or shifted posts after storm surge. Sandy, high-water-table soil doesn’t hold a shallow footing when hurricane water pushes through. Slide gates bind on the rack and pinion, and swing gates drag on the ground after the storm passes.
- Dead keypads and intercom panels steps from the surf. Uncovered entry keypads on beachfront buildings corrode internally even when the buttons still click. The operator runs fine; the access device is the failure point.
Pricing for Gate Repair in Lauderdale-by-the-Sea, FL
A hinge and post reset on a standard single swing gate in Lauderdale-by-the-Sea typically runs $450-$850, depending on post condition and whether new stainless hinges are needed. Gate realignment runs $150-$300 in most cases. Electric gate repair, like a control board replacement, runs $300-$700 including the part on common Linear and DoorKing boards. Weld and rust repair on a wrought iron gate runs $200-$600 depending on how much rail needs cutting out. Every price is written before work starts, so the number on the invoice matches the number you approved. Call (754) 666-7602 for a free estimate, and if you already have a written quote from another company, bring it to us for a free second opinion.
We Also Serve Cities Near Lauderdale-by-the-Sea

Vance Gate Repair covers all of Gate Repair in Lauderdale-by-the-Sea and the surrounding coastal communities, including Boca Raton, Deerfield Beach, Delray Beach, and Lighthouse Point. Dispatch and scheduling are coordinated from our South Florida office, and our crews run these routes daily, so you’re not waiting on a far-flung tech.
The Salt Reality: Why Lauderdale-by-the-Sea Gates Fail Faster Than Inland Gates
Here’s the thing about Lauderdale-by-the-Sea that no one outside this town fully gets: you cannot buy a “standard” gate hinge and expect it to survive. The town is barely a square mile, and the Atlantic sits within a few hundred yards of virtually every gate in it. Salt spray carried off the ocean doesn’t just sit on the surface, it works into the pivot points, the operator housing, and the steel under the powder coat. A galvanized hinge that would last fifteen years in Deerfield Beach can seize and crack in three to five years here. A LiftMaster arm operator that runs fine a mile west on Commercial Boulevard can short out from salt intrusion on El Mar Drive in half its expected life. That’s not a guess, it’s the failure cycle we see on every block from the pier down to the Hillsboro Inlet side.
This is why we push marine-grade stainless components on hinge rebuilds and sealed safety photocells on operator replacements. It’s not an upsell. It’s the math of the environment. A homeowner who replaces a rusted hinge with the same galvanized part is going to call us again in four years, and we’d rather not take your money twice for the same failure.
The Older Gates of Lauderdale-by-the-Sea: Repair or Replace?

Lauderdale-by-the-Sea’s housing stock was largely built during the beach-resort boom between the 1950s and 1970s, and a lot of the original gates are still hanging. Wrought iron gates from that era have a look that’s hard to reproduce, but their hinge posts and lower rails were never specified for decades of oceanfront salt. The honest answer is that some of these gates can be saved and some can’t. If the post is sound and the rail rot is limited to a section we can cut out and weld fresh steel into, repair makes sense and costs less than replacement. If the post has rusted through below grade, or the bottom rail is more Swiss cheese than steel, you’ll spend more patching it over five years than a new marine-grade gate would cost once. We’ll show you photos of what the metal looks like after we clean it, and we’ll price both paths in writing before you decide.
Key Takeaways for Lauderdale-by-the-Sea Gate Owners
- Salt air isn’t a filter condition; it’s the primary material selector for every hinge, post, and operator on an oceanfront gate.
- Original 1960s and 1970s gates can often be repaired, but the hinge post condition below grade decides it, not how the gate looks from the street.
- Vacation rental buildings have a different failure pattern than single-family homes: cycle counts, not weather, kill the travel sensors.
- Every repair from Vance Gate Repair comes with a written price before work, a photo record after, and a 365-day warranty on the work.
One Job We Won’t Forget on El Mar Drive

Our crew replaced a 1970s galvanized steel swing gate on El Mar Drive in Lauderdale-by-the-Sea after the hinge post, anchored in sandy, high-water-table soil, had shifted from storm surge and the gate’s LiftMaster operator had shorted from salt intrusion. We reset the post with a deeper concrete footing, rebuilt the hinge with stainless components, and installed a marine-grade FAAC operator with a sealed safety photocell, then corrected the sag on the aged rack and pinion slide gate at the building’s pool entry. The homeowner got photos of the old post before the concrete pour and the new settings dialed in on the FAAC board. That’s the job record we leave on every visit.
Serving Lauderdale-by-the-Sea, FL - Our Local Coverage Area
We’re based in the Lauderdale-by-the-Sea area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Lauderdale-by-the-Sea

In most Lauderdale-by-the-Sea cases, the gate didn’t fail, the hinge post moved. Posts set in the town’s sandy, high-water-table soil can heave or shift after storm surge or heavy rain, and a post that moves even half an inch makes a swing gate drag. If the post was set with standard galvanized hinges instead of stainless, corrosion accelerates the sag. The fix is a post reset with a deeper footing and, where the old hardware is degraded, new stainless hinge leaves. Call (754) 666-7602 and we’ll diagnose the post before we touch the gate.
Your gate is cycling far more than it was ever rated for. A vacation rental building in Lauderdale-by-the-Sea can see a gate open and close hundreds of times over a holiday turnover, and the limit switch and loop detector wear out from that repetition faster than mechanical parts fail. The symptom appears after the weekend because the switch finally crossed its wear threshold. We replace the travel sensor or loop detector, and we’ll set the operator travel so the gate stops gently instead of slamming the stops a hundred times a day. Call (754) 666-7602 for an exact diagnosis and a written price before we start.
We can repair many original Lauderdale-by-the-Sea wrought iron gates, but it depends on what the post and lower rail look like under the rust. If the hinge post is solid below grade and the rot is limited to a section of rail, we cut out the bad steel, weld in new stock, and the gate runs for years. If the post has rusted through or the lower rail is structurally gone, replacement is the cheaper long-term answer because you’ll be chasing patches every year. We’ll show you photos either way, and price both options in writing before you choose. Call (754) 666-7602 for that assessment.
Storm surge and heavy rain saturate the sandy soil under beachfront lots in Lauderdale-by-the-Sea, and the gate posts can heave or shift as the ground swells and drains. A shifted post throws the rack and pinion out of line, and the gate binds on its track even if the motor is fine. The repair is a post realignment or reset, not an operator replacement. Call (754) 666-7602 and we’ll measure the post alignment in person before recommending any work.
In Lauderdale-by-the-Sea, we see keypads and intercom panels corrode internally from salt air even when the buttons still click. The operator runs fine because the problem is in the access device, not the motor. We replace the keypad or intercom panel with a unit we can seal against direct oceanfront exposure, and we verify the wiring from the panel to the operator is still sound. Call (754) 666-7602 and we’ll tell you what’s failed before we order a part.
For Beachfront Gate Repair, Call the Crew That Documents Everything
Lauderdale-by-the-Sea is too small and too close to the ocean to settle for a gate repair that ignores why the gate failed. We’ll show you what we found, tell you what it costs in writing before we start, and leave you with a photo record of every adjustment. For any gate issue in Lauderdale-by-the-Sea, call (754) 666-7602. A live person answers.
Written by Adrian Vance, Owner at Vance Gate Repair Boca Raton, serving Lauderdale-by-the-Sea with documented gate repair since 2014.





Before
After
Before
After